Happymodel Mobula6 Freestyle HD
Happymodel Mobula6 Freestyle HD
Couldn't load pickup availability
Description
The Happymodel Mobula6 Freestyle HD BNF is the first 65mm HD brushless tiny whoop that weighs less than 19.6g. With tiny whoops, every gram makes a large difference in flight performance. To achieve such a low weight, HDZero has developed the world’s first 5-in-1 AIO that contains a HDZero VTX, FC, ESC, ELRS RX, and 5V1A BEC. Using a single thick PCB rather than a stack of 2 improves durability and simplicity – get ready for a new era of no-compromise tiny whooping in clear digital video!
Focusing on freestyle flying, this whoop includes the Runcam HDZero Lux camera and a vibration-free fixed angle 25deg camera mount. The camera features a ½ inch CMOS sensor that delivers sharp image quality and excellent low-light performance. Lux camera has Wide Dynamic Range (WDR) and offers higher quality by oversampling (1080p ‐> 720p). The camera outputs HD composite video (720p) via a single wire instead of a MIPI cable, reducing footprint, cost, and increasing durability.
Optimized for a 4:3 aspect ratio, it can also be configured for a 16:9 aspect ratio with a reduced vertical FOV. The camera boasts a large 94-degree vertical FOV, ideal for fast indoor and outdoor proximity flying. The digital video signal has stable color reproduction and 720p progressive scan video with the stable near-zero latency HDZero is known for.
Specifications
- Weight: 19.6g
- Recommended Battery: 1S 300mAh with A30 or BT2.0 plug
- Propeller Size: 31mm
-
AIO
- MCU: STM32F411 (100MHz, 512K Flash)
- Gyro: BMI270
- On board voltage and amperage meters
- Built-in 5A(each) BLHeli_S 4-in-1 ESC
- Bluejay ESC firmware pre-installed
- Built-in 5.8G HDZero VTX
- Built-in SPI ExpressLRS 2.4GHz receiver compatible with ExpressLRS v3.0
- Built-in 5V 1A BEC
- Board size: 28.5x28.5mm with a 25.5x25.5 mounting hole size
- Betaflight firmware: CRAZYBEEF4SX1280 4.4.2 from factory
- HDZero Lux Camera
- Sensor size: 1/2 inch
- Resolution: 720p60 4:3 and 16:9
- FOV: D:155° H:126° V:94°(4:3)
- FOV: D:145° H:126° V:70°(16:9)
- WDR
- Motors
- Kv:28000
- Stator diameter: 7mm
- Stator length:2mm
- Shaft diameter: Φ1mm
- Weight:1.5g
Included
- 1x Happymodel Mobula6 Freestyle BNF
- 1x Spare canopy
- 1x Spare propeller(set)
- 1x Screw driver
- 1x propeller disassemble tool
Share
Great little drone. So much fun to fly. Very durable.
This thing rips hard. Just over all control and capability with this is phenomenal. Not disappointed at all
Excellent video, but get ready for motor desync issues if you actually try to freestyle this aircraft. This issue was out of the box, so not something caused by a crash or damage. I have tried everything in the tune and in the esc software to eliminate the issue, also tried different props, but it is still an issue. Desync issue shows up when trying to split s, power loop, flips and rolls, punch outs, anything requiring more than 75% throttle.
Going to try a different set of motors from WeBleed. Happy with the video quality, but hate the desync issue. If you buy it, don’t expect to freestyle it. I’ll update this if the new motors solve the problem, not happy with spending another $60 to solve an issue that shouldn’t be there out of the box.
I love this thing, I have probably 3-400 packs through it, it stays in my bag on all my trips and is the perfect hotel/office flyer. Incredibly durable, I've only had to replace the VTX antenna, which eventually snapped after probably hundreds of crashes.
Awesome, fast shipping